<address id="pd5d5"><address id="pd5d5"><nobr id="pd5d5"></nobr></address></address>

    <ruby id="pd5d5"></ruby><span id="pd5d5"><pre id="pd5d5"></pre></span>
    <address id="pd5d5"></address>

      That's the right way to keep the bending machine

      CREATE_TIME:2018-7-2 VIEWS:2509
        Some buyers buy a bending machine, use less than two years after the failure of the time (except poor quality machine tools), the problem is in the use and maintenance of the machine.Now let's see if you have done the right thing in using and maintaining the bending machine.
       
        Precautions for use
       
        1.Before running the bending machine, the tools used must be matched with the control program
       
        2.Be sure to turn off the bender after work
       
        Two ways to turn off a bender
       
        1. Close the machine to the middle of the lower dead center, that is, move the slider to the center of the lower dead center, close the main motor, and set the operation switch to "0", and the main switch to "0".。
       
        2. Turn off the bending machine with two pieces of wood of the same height. Place the two pieces of wood on the work table and set the operation mode selection button to "2".When the bending mechanism is closed, manually pull down the slider until it can touch the wood block.Then adjust the operation mode selection button to "0", and finally adjust the main switch to "0".。
       
        Use the emergency stop button
       
        When the emergency stop button is used, all shafts and pumps will stop, but the control system is not closed.Please restart the machine: first release the emergency stop button, and then press the green button to run the machine.No need to reset the upper and lower die parameters.
       
        Bending machine maintenance
       
        requirements
       
        1.It is suggested that when maintaining and overhauling the bending machine, the staff should have some experience and read the operation manual of the bending machine carefully。
       
        2It is recommended that the bending machine manufacturer repair the machine tool
       
        3The machine operator should check the machine every day to avoid oil leakage or loose parts
       
        4.If you can not solve the machine failure, it is recommended to contact the bending machine manufacturer in time
       

      Related articles

        <address id="pd5d5"><address id="pd5d5"><nobr id="pd5d5"></nobr></address></address>

        <ruby id="pd5d5"></ruby><span id="pd5d5"><pre id="pd5d5"></pre></span>
        <address id="pd5d5"></address>
          成 人 色综合_影音先锋最稳定资源_狠狠狠的在啪线香蕉人_亚洲欧美中文字幕先锋,亚洲区小说区综合图片,另类小说视频一区,男人和女人特黄的视频